1. The beam and end milling head are equipped with fully automatic mechanical pressing and hydraulic relaxing functions. The degree of automation is relatively high.

2. The milling head is equipped with a built-in flywheel to increase cutting stability.

3. The feed movement in all directions adopts stepless speed regulation; when the fast forward power of the workbench is less than or equal to 15KW, variable frequency stepless speed regulation is generally used; when the fast forward power of the workbench is greater than 15KW, servo stepless speed regulation is used.

4. The workbench adopts a new technology of wear-resistant plastic guide rails, which can reduce the wear of the bed guide rails.

5. The workbench adopts worm and worm drive, which makes the movement more stable (screw drive is used for 6M and below).

6． The worm and worm strip of the workbench are lubricated by an independent oil tank, the guide rail of the workbench is lubricated by a special lubrication pump, the milling head is lubricated by an independent plunger pump, the beam column guide rail and the beam column screw are lubricated by an electric gap lubrication pump. The whole machine has good Anti-friction lubrication properties.

7． The bed and beam guide rails adopt ultrasonic quenching heat treatment; the main spindle box transmission gear is 20CrMnTi, carburized, quenched and ground; the spindle is quenched and tempered with 40Cr, and the inner cone and its end are quenched in a salt bath.

8. A boring and milling head with a stroke of 300 or 500 or a milling head with rotation can be installed according to user requirements. The rotation of the end milling head is ±45°, and the side milling head is lowered at +45° and raised at -10°.

9. According to user requirements, a digital display can be installed or the frequency conversion speed regulation can be changed to a servo speed regulation and an electronic handwheel can be installed to achieve fine adjustment of the coordinates of the workbench. It can be equipped with a touch screen control mode to enable the machine tool to have simple programming functions to realize plane or keyway processing. Automatic cycle milling.

10. When equipped with a boring and milling head and servo speed adjustment, a right-angle milling head or an angle milling head and a cooling system can be installed.